Power semiconductor device

Power semiconductor devices first appeared in 1952 with the introduction of the power diode by R.N. Hall. It was made of Germanium and had a voltage capability of 200 volts and a current rating of 35 amperes.

The thyristor appeared in 1957. Thyristors are able to withstand very high reverse breakdown voltage and are also capable of carrying high current. One disadvantage of the thyristor for switching circuits is that once it is 'latched-on' in the conducting state it cannot be turned off by external control. The thyristor turn-off is passive, i.e., the power must be disconnected from the device.

The first bipolar transistors devices with substantial power handling capabilities were introduced in the 1960s. These components overcame some limitations of the thyristors because they can be turned on or off with an applied signal.

With the improvements of the Metal Oxide Semiconductor technology (initially developed to produce integrated circuits), power MOSFETs became available in the late 1970s. International Rectifier introduced a 25 A, 400 V power MOSFET in 1978.[1] These devices allow operation at higher frequency than bipolar transistors, but are limited to the low voltage applications.

The Insulated Gate Bipolar Transistor (IGBT) developed in the 1980s became widely available in the 1990s. This component has the power handling capability of the bipolar transistor, with the advantages of the isolated gate drive of the power MOSFET.